The second way is to restore the factory settings. Once it starts, the original system will not
start. Please use this function carefully.
Restoring factory settings can restore the device to its initial state, but the firmware version will not be
restored (the factory default IP address of the device is DHCP manual mode. If there is no router that auto-
matically assigns IP addresses in the LAN, the device IPwill change to 192.168.8.8).
Modify the login password and click apply. After the password is modified, it will take effect at the next login.
The second is to restore all the settings on the firmware version and WebUI to the factory.To restore the
factory settings, you need to power off the device, press and hold the reset key on the device from the small
hole, and power on the device at the same time. Whenyou see system recover on the first line of the device
screen, you can release the reset key.During the process of restoring the factory settings, tally lights up the
red light and starts flashing, When "burning: 100" is displayed on the second line of the screen, tally always
lights up in green, and the whole process takes about 20 minutes to complete. At this time,power on the
equipment again.
10.1 Reset login password
10.2 Restore factory settings
18