SciCan hydrim c51w, Руководство оператора, Страница: 21 / 59

5. Instructions for Use
5.10 Opening the Door in Case of Power Failure
If there is a power failure, open the detergent door and remove
the chemical bottle. Keep the chemical bottle upright and
ensure that the chemical does not spill. Locate the ring in
the top of the detergent compartment and pull it to open the
door. Exercise caution! There may be fluid remaining in the
unit and the instruments may be hot. Instruments that have
not completed the cycle should not be used and should be
reprocessed.
5.11 Printer / USB Setup
The HYDR IM C51w has an RS-232 port at the back, and can be used with an external
printer or the SciCan Data Logger. The printers in the chart below have been tested
with the HYDR
IM . To add or change a printer or SciCan Data Logger, follow these steps:
Turn off the HYDR IM and the printer or Data Logger before connecting these devices
to the unit.
1.
With the printer or Data Logger connected, turn on the HYDR IM and press the i to
move to the Menu screen.
2.
In the Setup Menu, select Printer Selection.
3.
Select Serial Printer if connecting
a printer, or USB Flash/MSD if
connecting the SciCan Data Logger.
Press the back arrow to return to
the Setup Menu.
4.
In the Setup Menu, select Baud rate.
5.
Select the rate required (refer to
chart below for recommended Baud
rates). Use the back arrow to return
to the Start screen.
6.
Ensure that the date and time
have been set (see Setup Menu –
Date / Time).
7.
Now the HYDR IM will write its cycle
information to the device chosen.
Page 19
Printer Model Serial Port
Baud Rate
Epson
TM-U220D 9600
Citizen
IDP-3110-40 RF 115 9600
Star Micro
SP212FD42-120 9600
Star Micro
SP216FD42-120 9600
Star Micro
SP512MD42-R 9600
SciCan Data Logger Serial Port
Baud Rate
For Mass Storage Device 9600