Schwank ThermoControl Plus 4M, Руководство по эксплуатации и установке

Страница: 16 / 33

- 16 -
5 Set up the operating parameters
The
setup parameters can be modified from the front panel. To modify the
parameters you have to have technical knowledge, otherwise
proper
operation can not
be guaranteed. Inside the controller there is a sliding switch to avoid unwanted
functional changes, thus
parameters can be locked. The switch is located in the upper inside of the control unit. Permit
the setup: „ON”, avoid the setup: „OFF”.
Before you open the control unit, please read the important notes in chapter 2! The
„setup”-switch as well as the selection of the program P1 and P2 may only be carried out
after the power routed to the controller has been cut off.
The main operation program can be selected inside the controller unit(P1, P2, P3, P4, P5).
A small “jumper“ has to be placed in the correct position. Only one program can be chosen at
any given time. Please be careful by choosing the right electrical connection for the desired
program!
In case of changing the application program(P1, P2, P3, P4, P5) all parameters switch back to
the default settings (chapter 5.1 and 5.2) !
P1 - Eight heating zones, single-stage
P2…P5 – Four to seven zones, single-, two-stage or modulation control
5.1 Enter the number of heating zones
The controller is able to manage four to eight control zones, depending on the chosen operation
program. In the following example we are fixing the actual number of control zones.
Get back to the default screen by pushing the DISP button.
Hold the ZONE button for about 3
seconds. The number of available
heating zones appears on the
screen (for example.: 1-8: eight
heating
zones). The desired
number of heating zones can be
selected if you push
+/- (1-7).