Schwank ThermoControl Plus 4M, Руководство по эксплуатации и установке

Страница: 11 / 33

- 11 -
4.4 Timing
Every heating zone has an independent
schedule
program, which can be modified.
The time program is a series of different switching times or switching points. The
controller changes automatically from daytime , to night time or frost protection mode .
A
n on/off command
can be described as:
- time (hour and minute)
- operation mode , or , which will start at this time
- day of the week, or couple of days, when the
on/off command
should be active
(1 = Monday, 2 = Tuesday ……7=Sunday)
- number of
on/off command
(max. 19 times in one program)
4.4.1 How to read a time program
To see the time program in the selected zone push the PR button.
Then
display will jump to the first
programmed on/off command.
When press the PR button
repeatedly the stored
on/off command
will appear one by one. Over the symbol the number of
the
on/off command can
be seen, on the upper part of the display the " 1 2 3 4 5 Day " informs
that on what days of the week ( 1= Monday…) will this
on/off
function be active. With a
few press es on the PR button you can see the full weekly heating program. Two
examples can be seen here:
At the
on/off
( 7:00 ) daytime
mode heating is
started. Then at time point 2 (
17:30 ) the night time mode
heating begins. As
these two points are valid on
the first five days of the week
( 1 2 3 4 5 Day ) and there
are no other programmed
points for the last two days ( 6
7 ) the whole weekly program
is described with these two
command
points.
In the next example this
program is extended with two
additional
on/ff
commands
: on Saturday ( 6
Day ) at the time 3 ( 8:00 )
day mode heating is started,
then at time point 4 ( 12:45 )
the frost protection mode
begins. This mode will be
active until the next
on/off
command
( 1 ) that is on Monday.
When you first press the PR
button: for a short time the
display will show the number
of free
on/off command
locations (here:17 free points).