Assembly
05.00 | WSG 25 | Assembly and Operating Manual | en | 389684
25
5.3 Installation of the fingers
To install fingers, use two cylinder head screws M3. The lower end
of the screw mustn’t reach out of the base jaw to prevent damage
to the housing. Pins can be used to determine the exact position
and orientation.
Gripper finger
Screw M3
Pin Ø2 mm
Base jaws
Installation of the fingers
NOTICE
Material damage due to inadmissible tightening torque!
Observe the maximum tightening torque:
– Screw M3: 1.0 Nm
