Operation
16
03.00 | Clamping Device SVP-2 | Assembly and Operting Manual | en | 0289021
CAUTION
Material damage due to incorrect handling!
Deformation of the intermediate sleeve by clamping without
reduction insert and TRIBOS toolholder.
•
Intermediate sleeve clamp with reduction insert and TRIBOS
toolholder only.
CAUTION
Risk of injury due to sharp-edged tools.
•
Wear protective gloves at tool change.
Ø
Observe the pressure specifications of the toolholder.
Ø
Push the reduction insert onto the toolholder until it snaps in
via the flattened areas. In order to eliminate possible play
between the flattened area and the reduction insert, turn the
toolholder, which is clamped into the reduction insert, to the
right (clockwise).
Ø
Slide the reduction insert and the toolholder into the clamping
device until the stop. The position is automatically determined
by the three segments of the reduction insert in the large
intermediate sleeve of the clamping device at an angle of 120°.
Ø
IMPORTANT! Check that the toolholder and the reduction
insert are correctly inserted to the stop and that any possible
toolholder play is eliminated.
Ø
Close the pressure release valve and actuate the manual pump
until the required pressure is achieved.
✓
The tool/workpiece can be inserted or removed now.
Ø
To unclamp the device, open the pressure release valve.
✔
The reduction insert with the toolholder can be removed from
the clamping device. The toolholder is now ready for use.
