Assembly
38
11.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443
5.4.1 Adjust swivel angle
CAUTION
Material damage due to incorrect settings!
By incorrect setting of the swivel angle parts can come loose and
the product may be damaged.
•
Only trained stuff may set the swivel angle.
•
Before setting the swivel angle release pressure.
Version with clamp
shell
1. Loosen screw of the limiting sleeve (6) approx. one revolution.
2. Actuate air connection
B
(4).
3. Open exhaust throttle valve on air connection
A
(3) until the
pinion (5) starts to move.
✓
Pinion swivels towards the end position.
4. Set the desired end position by twisting the stop
B
(2).
5. Check end position.
✓
To do this, ventilate air connection
B
(4) and actuate it
again, if necessary adjust end position.
6. Tighten screw (6).
7. Loosen screw of the limiting sleeve (7) approx. one revolution.
8. Ventilate air connection
B
(4) and actuate air connection
A
(3).
9. Open exhaust throttle valve on air connection
B
(4) until the
pinion (5) starts to move.
✓
Pinion swivels towards the end position.
10. Set the desired end position by twisting the stop
A
(1).
11. Check end position.
✓
To do this, ventilate air connection
A
(3) and actuate it
again, if necessary adjust end position.
12. Tighten screw (7).
✓
Tightening torque:SRU-plus 20-30: 1.2 Nm / SRU-plus 35-50:
2.1 Nm
13. Swivel repeatedly to test the setting, adjust if necessary.
