Assembly and settings
03.00 | RP / RW / RC | Assembly and Operating Manual | en | 389392
27
5.4.5 End position monitoring
Two options are available for the end positions monitoring:
• By magnet sensors MMS
• By inductive sensors via standardized monitoring sets
Attachment / adjust-
ment MMS magnet
sensors
With the MMS sensor, the magnet integrated in the piston is mon-
itored.
NOTICE
Material damage due to an incorrect tightening torque!
If the threaded pin is tightened with an incorrect tightening
torque, the product may be damaged.
•
Observe a maximum tightening torque of 10 Ncm for the set-
screws.
MQL sensor attachment
3.0
Max.
10 Ncm
For monitoring of the two end positions, one sensor each is in-
stalled.
■
Piston is in the respective end position.
Ø
Turn the sensor into the groove.
Ø
Push the sensor into the groove until the signal is present at the
output.
Ø
Fix the magnetic switch into this position by tightening the set-
screw with the Allen key.
Ø
If need be, repeat the procedure with the second sensor and
the opposing piston position.
