Assembly and settings
26
03.00 | RP / RW / RC | Assembly and Operating Manual | en | 389392
5.4.4 Adjusting the end positions
The following parts are included within the scope of delivery for
angle of rotation fine adjustment and adjustment of the end position
dampening to the mass moment of inertia occurring in operation.
• Stop coupling (10)
• Counter nut (11)
• Counter nut (12)
• Shock absorber (18)
Adjustment of end position RM12/15/21
Angle of rotation
fine adjustment
Ø
Release counter nut (11).
Ø
Each end position can be adjusted to any angle between -5° and
+90° by twisting the stop coupling (10) with the shock absorber
(18) integrated in it.
Ø
Tighten the stop coupling again with the counter nut.
Dampening adjustment
NOTICE
Use the shock absorber!
Operation without the shock absorber included within the scope
of delivery is not permitted.
•
Ocserve the maximum mass moment of inertia (see catalog).
•
Adjust the dampening at the mass moment of inertia.
•
See chapter
Setting the swiveling time
[
}
24].
■
The desired angle of rotation has been set.
Ø
Release counter nut (12).
Ø
By turning the shock absorber (18) in and out, the stroke of the shock
absorber (and therefore the shock absorber characteristic curve) can
be adjusted to the mass moment of inertia occurring in operation.
✓
The previously adjusted angle of rotation is not influenced by this.
Ø
Tighten the absorber again with the counter nut.
