SCHUNK 1487783, Сборка и руководство по эксплуатации

Страница: 39 / 44

Maintenance
9 Maintenance
9.1 Safety
Maintenance work may only be carried out by qualified personnel.
WARNING
Risk of injury due to incorrect maintenance or troubleshooting
•
Check the proper functioning of the product, especially the
safety features, after every maintenance or troubleshooting
operation.
CAUTION
Improper installation or maintenance
Personal injury or damage to property
•
Prior to installation and before maintenance work, the
product must be disconnected from the power supply,
depressurized (vented to the atmosphere) and secured
against unauthorized restart.
9.2 Maintenance and Cleaning of the Steel-Plate ISST-SMPL
The sealing gasket between the Matrix-Plate and the Steel-Plate
must be replaced in the case of visible wear or damage. A faulty
sealing gasket causes leakage between the Steel-Plate and Matrix-
Plate. Before applying or positioning the clamping equipment
(setup), the Matrix-Plate and the Steel-Plate must be cleaned
thoroughly (e.g. with a cloth) to remove any dirt and
contamination.
9.3 Maintenance and Cleaning of the Suction Cups ISBL
The seals of the suction cups ISBL must be replaced in the case of
visible damage, e.g. due to wear. To do so, simply pull the
damaged seal out of the slot and thoroughly clean the slot. Wet
the new seal slightly, e.g. with soapy water or some cooling
lubricant, and press it in by hand. The friction pad cannot be
replaced. Before each machining process, clean the suction cups to
remove any coarse dirt and cooling lubricant.
9.4 Maintenance and Cleaning of the FlexMat SFM
The FlexMat should be replaced in the event of damage. Before
each machining process, clean the FlexMat to remove any coarse
dirt and cooling lubricant.
Note regarding cleaning of elastomer parts:
39 01 | SMPL with ISST, SFM and ISBL | Assembly- and Operating Manual | en-US |
1512656