•
6
•
Open the protective cover of the DC power outlet on the left side of the
8.1
Instant Power.
Make sure that the device to be powered is OFF before inserting the 12V
8.2
accessory plug into the 12V accessory outlet.
Plug the 12V DC device into the DC power outlet and turn it ON (if re-
8.3
quired).
If the 12V DC device draws more than 15A, the Instant Power internal
8.4
circuit breaker will stop powering the device. If this occurs, unplug the de-
vice and the circuit breaker will automatically reset after several seconds.
The DC power outlet is internally wired directly to the internal battery.
8.5
Extended operation of the 12V DC device may result in excessive battery
drain. Recharge the battery immediately after unplugging the device.
USING THE USB PORT
9.
The USB port provides up to 500 mA at 5V DC.
Note:
The Jump Start + USB On/Off switch energizes both the jump start-
ing clamps and the USB port. Do not allow the clamps to touch each other
or the same piece of metal when the switch is ON (turned to the right).
Confirm that both jump starting clamps are stored on the storage holders,
9.1
or even better, that the Quick Connector is disconnected.
Turn the Jump Start + USB switch to the ON position.
9.2
The USB plug is now live; plug in the accessory.
9.3
USING THE AIR COMPRESSOR
10.
CAUTION
– Read instructions of the product being inflated before using
the compressor. Avoid over-inflation, do not exceed the manufacturers
recommended pressures. Do not leave the compressor unattended during
use.
The 12 volt compressor is rated for 150 PSI pressure. The hose is stored
on the back of your Instant Power.
The ON / OFF switch for the compressor is located on the back of the
Instant Power.
Attach the air compressor hose to the product or accessory to be inflated
10.1
by flipping down the lever.
Push the air compressor switch to the ON position and inflate product.
10.2
When the product is inflated to the proper air pressure, press the com-
10.3
pressor switch to the OFF position and remove the hose.
Do not run compressor for more than 10 minutes maximum at a time. Al-
10.4
low the compressor to cool down for 10 minutes before using again.
