•
4
•
DO NOT turn your Instant Power on. This could cause serious damage.
Remove the ring terminals and reinstall correctly, per section 4.1.
If no audio alarm is sounded, turn ON the Jump Start switch and then
•
crank the engine. If the engine does not start within 5-8 seconds, stop
cranking and wait at least one minute before attempting to start vehicle
again. (This permits the battery to cool down.)
After the engine starts, make sure to turn OFF the Jump Start switch.
•
Disconnect the Quick Connector.
•
CONTROL PANEL
5.
LED INDICATORS (
6.
red
,
yellow
and
green
lights
)
To check the internal battery charge status, press the Battery Status But-
6.1
ton on the front of the Instant Power.
The LED lights will indicate the charge level as follows:
6.2
A red LED indicates the internal battery has a 50% or less charge.
•
A yellow LED indicates the internal battery has a 50% to 75% charge.
•
A green LED indicates the internal battery has a 75% to 100% charge.
•
NOTE:
If the red LED or the yellow LED glows, immediately recharge the
Instant Power internal battery.
CHARGING THE INTERNAL BATTERY
7.
This Instant Power, IP-180KE comes with a sealed, non-spillable, mainte-
nance-free, lead acid battery. This internal battery is specifically designed
to deliver high power jump-starting as well as repetitive deep-cycling
performance.
IMPORTANT:
Charge the Instant Power immediately after removing it
from the package for a minimum of eight hours, even if the green FULL
(charged) LED glows. Charge the Instant Power after every use and every
30 days so that it is available for immediate use when needed.
