• 11 •
12. DISPLAY MESSAGES
0.0V – No battery is detected.
CONNECT CLAMPS (Voltage LED lit) – Plugged into the AC outlet without the clamps connected
to a 6 or 12V battery.
xx.xV – Battery voltage is displayed.
---- – Battery percentage is not yet available (starting voltage is below 8.0V).
xx.xA – Charging current is displayed.
xxo/o –Percentage of battery charge is displayed.
WARNING - CLAMPS REVERSED (red Reversed LED flashing) – Plugged into the AC outlet and the
clamps are connected backwards to a battery. Scrolls until condition is corrected.
ANALYZING BATTERY (yellow/orange Charging LED lit) – The charger is checking the condition of the battery.
BAD BATTERY – A sulfated battery is detected.
CHARGE ABORTED - BAD BATTERY Circumstances that could cause an Abort situation during charging:
• The battery is severely sulfated or has a shorted cell and can’t reach a full charge.
• The battery is too large or there is a bank of batteries and it doesn’t reach full charge within a set time period.
Circumstances that could cause an Abort situation during maintaining:
• The battery is severely sulfated or has a weak cell and will not hold a charge.
• There is a large draw on the battery and the charger has to supply its maximum maintain current for a 12
hour period to keep the battery at full charge.
CHARGING 6V – xxo/o (yellow/orange Charging LED lit) – Plugged into the AC outlet and correctly
connected to a discharged 6V battery.
CHARGING 12V – xxo/o (yellow/orange Charging LED lit) – Plugged into the AC outlet and correctly
connected to a discharged 12V battery.
BATTERY DISCONNECTED – The charger’s connection to the battery has been lost.
FULLY CHARGED - AUTO MAINTAINING (green Charged/Maintaining LED solid) –
Plugged into the AC outlet and correctly connected to a fully charged 6 or 12V battery.
BOOST ON (yellow/orange Charging LED lit) – The charger is in Boost mode.
ENGINE START ON – Shows during the first 2 minutes of Engine Start mode.
READY (yellow/orange Charging LED lit) – Shows after 2 minutes in Engine Start mode.
The charger is ready for Engine Start.
COOL DOWN xxx SECONDS REMAINING (yellow/orange Charging LED lit) – The charger is in a
mandatory 3 minute (180 second) cool down state.
13. MAINTENANCE AND CARE
A minimal amount of care can keep your battery charger working properly for years.
• Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come
in contact with the clamps to prevent corrosion.
• Occasionally cleaning the case of the charger with a soft cloth will keep the finish shiny and help
prevent corrosion.
• Coil the input and output cords neatly when storing the charger. This will help prevent accidental damage
to the cords and charger.
• Store the charger unplugged from the AC power outlet in an upright position.
• Store inside, in a cool, dry place. Do not store the clamps on the handle, clipped together, on or around
metal, or clipped to the cables.
