Schmalz 10.02.02.05588, Руководство по эксплуатации

Страница: 28 / 52

Description of Functions
28 / 52 EN-US · 30.30.01.01963 · 01 · 09/21
6.11 Counters
The ejector has two internal counters, [
cc1
] and [
cc2
], which cannot be erased:
Counter 1 increases with each valid pulse at the “suction” signal input, meaning that it counts all the suc-
tion cycles during the ejector’s service life.
Counter 2 increases each time the “suction” valve is switched on. As a result, the average switching fre-
quency of the air saving function can be determined using the difference between counters 1 and 2.
Designation Display parameter Description
Counter 1
[
Cc1
]
Counter for suction cycles (suction signal input)
Counter 2
[
Cc2
]
Counter for the “suction valve” switching fre-
quency
Calling up the counter values
ü Select the counter you wish to see in the system menu.
4
Confirm your selection of counter 1 [
cc1
] or counter 2 [
cc2
] using the button.
ð
The first three decimal places of the counter total will be displayed (the digits x 10
6
). This corre-
sponds to the three-digit block with the highest value.
Use the button to display the remaining decimal places of the counter total, in order of descending
value. The decimal points show which 3-digit block of the counter total is shown in the display.
The counter total is comprised of the 3-digit blocks taken together:
Displayed section 10
6
10
3
10
0
Digit block
0.48 61.8 593
The current counter total in this example is 48 618 593.
Counter levels that cannot be deleted are saved only in increments of 1000. That means that
when the operating voltage is switched off, up to 999 counter steps are lost.
6.12 Displaying the part number
The part number of the ejector is printed on the label and also stored electronically.
ü The ejector is in the Info menu.
1. Use the button to select the part number parameter
Art
.
2. Use the button to confirm the part number parameter
Art
.
ð The first two digits of the part number are displayed.
3. Press the button again several times.
ð
The remaining digits of the part number are displayed. The decimal points shown are part of the
part number.
In the first block displayed, the point on the far right (after the second digit), which is part of
the part number, is not displayed for technical reasons.
The part number consists of 4 blocks with a total of 11 digits.
Displayed section 1 2 3 4
Digit block
10 02.0 2.00 383