Scheppach PL75, Перевод с оригинального руководства пользователя

Страница: 21 / 136

21 GB
ASSISTENCE
When in need of skilled personnel for special mainte-
nance, or for repairs, both during and following the guar-
antee pe riod, always apply to authorized centres for
assistance or directly to the manufacturer if there is no
authorized centre in your area.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the follow
-
ing parts are therefore also required for use as consum
bles. Wear parts*: Carbon brush, saw blade
* Not necessarily included in the scope of delivery!
Such defective electrical connection cables must not be
used as the insulation damage makes them extremely
hazardous.
Check electrical connection cables regularly for dam-
age. Make sure the cable is disconnected from the
mains when checking.
Electrical connection cables must comply with the regu-
lations applicable in your country.
Single-phase motor
• The mains voltage must coincide with the voltage
specified on the motor’s rating plate.
• Extension cables up to a length of 25 m must have a
cross-section of 1.5 mm2, and beyond 25 m at least
2.5 mm2.
• The connection to the mains must be protected with
a 16 A slow-acting fuse.
Only a qualified electrician is permitted to connect the
machine and complete repairs on its electrical equip-
ment.
In the event of enquiries please specify the following
data:
• Motor manufacturer
•
Type of current of the motor
• Data recorded on the machine’s rating plate
• Data recorded on the switch’s rating plate
18. Maintenance
If specialist personnel must be brought in for ex -
traordinary ser vice or repairs during the warranty
period and thereafter, please contact a service pro
-
vider recommended by us or con tact the manufac -
turer directly.
• Overhauls, maintenance work, cleaning, as well as
the eli mi nation of any malfunctions must only be un-
dertaken af ter turning off the motor.
• All protective and safety equipment must be rein-
stalled immediately upon completion of any repair or
maintenance work.
REGULAR MAINTENANCE
The regular maintenance decribed above and in the
para graph below can be carried out by unskilled per-
sonnel.
•
Do not oil the plunge cut saw, cause cutting must be
carried out in dry conditions; all rotating parts are
self-lubricating.
• During maintenance, wear protective gear if possible
(accident-prevention goggles and gloves).
• Remove cuttings when necessary both from the cut-
ting area, work surfaces and support bases.
Use of an aspirator or brush is recommended.
ATTENTION: Do not use compressed air jets!
Regularly check blade conditions: if difficulties should
arise during cutting, have it sharpened by skilled per-
sonnel or replace it if necessary.