Scheppach HL850, Перевод с оригинального руководства пользователя

Страница: 20 / 64

20 GB
1. Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschine GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment and
success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs due
to the non-compliance of the electric regulations and
VDE regulations 0100, DIN 57113 / VDE0113.
m
Important!
When using electric tools safety precautions should
always be followed to reduce the risk of fire, electric
shock and personal injury including the following. Read
all these instructions before attempting to operate this
product and save these instructions. Keep this manual
in a safe place, so that the information is available at
all times. If you give the equipment to any other person,
hand over these operating instructions and safety regu-
lations as well. We cannot accept any liability for dam-
age or accidents which arise due to a failure
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country. Keep the operating instructions package with
the machine at all times and store it in a plastic cover
to protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information. The machine can only
be operated by persons who were instructed concern-
ing the operation of the machine and who are informed
about the associated dangers. The minimum age re-
quirement must be complied with.
We assume no liability for accidents or damages result-
ing by disregarding these instructions and the safety in-
structions.
2. Layout (Fig. 1-3)
1 Handle
2 Riving knife
3 Splitting column
4 Set screw for clamping lug
5 Adjustable clamping lug
6 Operating arm
7 Handle guard
8 Support for table (front)
9 Support for table (side)
10 Locking hook
11 Splitting table
12 Venting cap
13 Base
14 Wheels
15 Switch and plug
16 Stroke setting rod
17 Motor
A Pre-assembled unit
B Operating arms right/left
C Table top
D Operating instructions
3. Scope of delivery
•
Open the packaging and remove the device carefully.
•
Remove the packaging material as well as the pack-
aging and transport bracing (if available).
•
Check that the delivery is complete.
•
Check the device and accessory parts for transport
damage.
•
If possible, store the packaging until the warranty pe-
riod has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
• Hydraulic log splitter (1x)
• Accessory pack (1x)
• Operating arms (2x)
• Fixed platform (1x)
• Wheel axle (1x)
• Running wheels (2x)
• Operating instructions (1x)