10
PUMP CONNECTIONS:
Connect the in/out hose to the pump as follows:
WATERMAKER CONNECTIONS:
IN – (sea water inlet from the pump) Make use, for this connection, of the external holder located
on the left side of the watermaker (marked IN).
OUT (Discharge outboard) Make use, for this connection, of the holder located on top of
the pressure amplifier, inside the watermaker unit (marked OUT). Create a Swan neck upward,
when the drain outlet on the vessel is positioned below the watermaker unit, in order to guarantee a
water head.
PRODUCTION FRESH WATER CONNECTION
The connection has to be made using the small
hose supplied with the equipment. The
connection has to be made between the
polyethylene
pipe
that
comes
out
the
watermaker unit (on the right), and the upper
side of the tank, on a ¼” outlet if available.
It is possible, in case of metal tanks, to make a
¼” threaded hole to connect the supplied male
connector.
Another option is to Tee into the tank air vent
hose.There are no particular limits on the
connection length.
Another option is to Tee into the tank air vent hose. This is only possible if the breather pipe section
is more than 16 mm. dia. There are no particular limits on the connection length.
