Operating and Installation - Battery Charger LAS 1218 BUS
8
Date: 21.11.2018
8100532 BA / EN
2 Installation instructions
2.1 Introduction
These installation instructions are aimed at trained personnel.
They contain important information on the connection and safe operation of
the device. The safety information provided must be observed.
Always follow the relevant instruction manual in addition to the installation in-
structions.
The following applications are described for the electrical connection (with
the appropriate deliverables):
F
Auxiliary charger on electroblock (section 2.3.1.1)
F
Auxiliary charger on electroblock in bus systems (Section 2.3.1.2)
F
Direct connection to leisure area and starter batteries (Section
2.3.1.3)
F
Connection to additional battery (e.g. when used in conjunction with
an inverter)
2.2 Mechanical installation
2.2.1 LAS 1218 BUS battery charger
Y
This device is intended for installation into a vehicle.
The device is designed for floor installation.
Install in a dry, sufficiently ventilated location. No condensation is allowed
to form on the device. To prevent a build-up of heat, ventilation holes fa-
cing the leisure area must be provided in the upper and lower areas of
the place of installation. Its cross-section is based on the size and ave-
rage temperature of the place of installation.
Ensure a minimum clearance to the surrounding fixtures and fittings:
F
Maintain a gap of at least 5 cm on all sides (except mounted side).
F
Whilst in operation, the ambient temperature must not 45
C,
measured 2.5 cm away from the sides of the device.
On a firm and level surface, tightly screw the battery charger with four
screws (5mm diameter).
Environment
Minimum clearance
Fitting
