Operating and Installation - Battery Charger LAS 1218 BUS
12
Date: 21.11.2018
8100532 BA / EN
3
4 5
X
X
1 2
TF 25 A*
To EBL connector
”Additional charger”
Fig. 3
Connection diagram for LAS 1218 BUS battery charger -- to electroblock
1
Flat push-on contacts, 6.3 x 0.8, red cable
2
Flat push-on contacts, 6.3 x 0.8, brown cable
3
Not assigned
4
+ Leisure area battery (red)
5
Negative battery (brown)
*
TF 25 A battery temperature sensor is optional
2-pin charger cable: LAS 1218 BUS electroblock connection
F
+ terminal LAS 1218 BUS leisure area battery: Flat push-on contact,
6.3 x 0.8; (Fig.3; Pos. 1)
F
-- terminal LAS 1218 BUS: Flat push-on contact, 6.3 x 0.8; (Fig.3;
Pos. 2)
F
MNL connector (view X, Fig. 3; Pos. 4/5) or Minifit connector on elec-
troblock, base ”auxiliary charger”; see also operating instructions for
electroblock
The following steps are only necessary when using the (optional) TF 25 A
battery temperature sensor:
Clamp the TF 25 A battery sensor to one of the terminals (preferable the
negative terminal) of the leisure area battery (note: this is NOT an electri-
cal connection -- only the temperature of the battery terminal is read with
this mechanical connection; this is virtually identical to the internal tempe-
rature of the battery)
Route the cable through the vehicle to the LAS 1218 BUS battery char-
ger.
Plug the TF 25 A battery temperature sensor into the LAS 1218 BUS bat-
tery charger.
Secure the battery sensor cable at suitable places (particularly near the
connector on the LAS 1218 BUS battery charger to prevent the 2-pin
connector from coming loose)
