Scanjet BIO 10, Инструкция по эксплуатации

Страница: 22 / 40

#BIO10 11 – 140813 Page 22 of 40
10. Mount the stator (pos. 8) and ball race
(pos. 5).
11. Use one or two points of Loctite 2046,
Scanjet art. no 250061-0,9, on the
thread of the supprot bearing (pos. 4).
Be careful! Too much Loctite will make it
diffi cult to disassemble. Use Scanjet tool
25255 to mount the support bearing as
shown on page 16. Minimum torque
to be applied is 80Nm (60Lb-Ft).
12. Insert turbine assembly and fl ow guide.
13. Mount the four locking shafts (pos.
7) in the stator (pos. 8). The rotation is
important and the chamfer should be
facing upwards as shown on the picture
below.
14. Also mount the pins on the locking ring (pos. 6) facing upwards.
15. Mount the connection by carefully pushing it onto the machine until it locks.
Check that all four locking shafts (pos. 7) have fallen into place.
16. Test run the machine to check that everything is working as it should!
7
Important
rotation
4
5
8