Document
9911004rev27
Title
Date
2017-02-16
Page
9(81)
SBS MicroSMART Battery Charger Technical Handbook
3.6.
Display
In the display charger status, parameters, and information can be viewed and edited. The
display lights up when a button is pressed, a battery is connected to the charger or a battery
is disconnected from the charger. In the display menu, the
Backlight
time can be edited
together with display
Contrast
.
3.7.
Shortcuts
F1
+
F2
pressed at mains supply power on.
The entire flash memory is cleared
including all configured parameters,
calibration values and statistical data. The
charger must be configured prior to use
after this shortcut has been used.
Warning!
The synchronization between the PC-
software SBS MicroSMART Service tool
and the charger will be lost. All data
stored in the SBS MicroSMART Service
tool that is related to the present charger
should be cleared.
OK
+
ESC
pressed at mains supply power on.
The charger is configured with
Default
settings
. The
Default settings
can be set or
reset in the
Factory settings
menu.
Arrow down
pressed for two seconds.
If the charger is connected to a radio
network
Join enable
is activated.
If the charger is not connected to a radio
network but the radio
Function
is set to
Enabled,
the charger tries to connect to a
network. If
Network Settings
are set to
Auto the charger will try to join any
network where
Join enable
is activated. If
Network Settings
are set to
User def.
the
charger will only try to join the specified
network.
