Document
9911004rev27
Title
Date
2017-02-16
Page
57(81)
SBS MicroSMART Battery Charger Technical Handbook
9.9.
Restore a forgotten PIN-code
We all know how easy it might be to forget a password. This tutorial will show how to restore
your level 1 and 2 access PIN-codes in case they are forgotten.
1.
At mains supply power on press and hold
OK
+
ESC.
This will configure the charger with
default settings. This means that your level 1 and 2 access PIN-codes will be reset to
their default values.
2.
Note that if you can’t remember your default PIN-codes the only option is to erase the
memory as mentioned in the tutorial
Start with a new control board
. This will reset the
PIN-codes according to the factory settings.
9.10.
Store and restore default settings
If some settings in the charger are frequently used it can be advantageous to store these as
the default settings. In case some parameters then are changed it is very easy to restore the
default values. Here follows a tutorial for how to store and restore default settings.
1. The default settings can be stored by going to the
Service menu→Factory
settings→Default settings
and click on
store
as shown in the picture below.
3.
If necessary, enter the level 2 pin-code and press
OK.
The following menu will be shown.
4.
Choose
Confirm
to make the current settings your default settings.
5.
In case you want to restore the default settings put instead the marker on
Restore
and
press
OK.
Choose
Confirm
to restore the default settings.
