Document
9911004rev27
Title
Date
2017-02-16
Page
46(81)
SBS MicroSMART Battery Charger Technical Handbook
9.3.
Set date and time
When installing a new charger or if the control board has been replaced with a new one it
might be necessary for the user to adjust the date and time to match reality. Because the
internal clock of the charger is used to keep track of for example scheduled charging it is
important that it is correctly adjusted. Here follows a tutorial for how to set the time and date
on the charger. Note that to edit time and date no pin-code is required.
1.
While in the service menu put the marker on
Date and time
and press
OK.
The
following menu will be shown.
There are three different formats for how the time and date should be entered. See
5.5.10 Date and time
for more information.
2.
To change the date put the marker on
Date
and press
OK
. Select the desired values
for year, month and date by using up, down, left and right arrows. Press
OK
to confirm.
3.
To adjust the time just follow the same procedure. Put the marker on
Time
and press
OK.
Select the correct values for hours and minutes using the up, down, left and right
arrows. Press
OK
to confirm when ready. Note that the time and date here was set
using the format ISO/JIS.
4.
Press
ESC
until the main menu is shown. The new date and time can be seen at the
top of the screen.
