ELLIPSE2 AHRS & INS
– Hardware Manual
ELLIPSE2HM.1.3
5.4.6. CA-ELI-SPLIT-RS232-DB-0.5M
This cable provides an easy access through standard
DB-9 plugs, to the different functions accessible on
the ELLIPSE Main port.
The cable is composed of the following elements:
●
1x UP01L07 M010S BK1 Z2ZA connector
●
Total length of 50cm (25cm before / after cable
splitter)
●
2x Male DB-9 plugs
●
1x DC 2.1mm jack socket for power supply input
●
Weight: 130g
Cable wiring of the two DB-9 connectors is the following:
Pin on DB-9
“PORT A”
Function
Pin on DB-9
“SYNC/PORT E”
Function
1
-
1
SYNC IN A
2
PORT A RX
2
PORT E RX
3
PORT A TX
3
PORT E TX
4
-
4
SYNC OUT A
5
GND
5
GND
6
-
6
-
7
-
7
-
8
-
8
SYNC IN B
9
9
-
The DC Jack plug is wired with VCC on the central pin and GND on the outer pin.
5.4.7. CA-ELI-SPLIT-CAN-DB-0.5M
This cable provides an easy access through standard
DB-9 plugs, to the main serial port as well as the CAN
bus output on the ELLIPSE.
The cable is composed of the following elements:
●
1x UP01L07 M010S BK1 Z2ZA connector
●
Total length of 50cm (25cm before / after cable
splitter)
●
1x Male DB-9 plugs (for serial PORT A)
●
1x Female DB-9 plug (for CAN bus)
●
1x DC 2.1mm jack socket for power supply input
●
Weight: 130g
46/50
Figure 5.9 : CA-ELI-SPLIT-RS232-DB-0.5M
Lengths not to scale
Figure 5.10 : CA-ELI-SPLIT-CAN-DB-0.5M
Lengths not to scale
陕西威瑞仪器仪表有限公司 主营全球知名：气象环境智能交通仪器、安防消防警用军用设备
TEL:029-88186182 WEB:www.go1go.com EMAIL:[email protected]
