ENGLISH
7
The state for “HOT” depends on the second
sensor, the bench sensor. If it is a temperature
sensor only, and the bench temperature in
the sauna room is 56°C or more, the steamer
cannot be activated. With the temperature
sensor, the user can choose the relative time
for the steamer to be on, within 30-100% of
the session time.
However, if the second sensor is combined
temperature humidity sensor, the maximum
bench temperature for the steamer to work is
80°C, as long as the relative humidity in the
sauna room is not too high. With the combined
sensor, the user can choose the relative
humidity inside the sauna room.
2.3.2 Water refill
When the water level is low, a low tone interval
beep and “FILL” will be displayed to alarm the
user. There are two possible ways to fill water
levels, automatically or manually, depending on
the model.
The auto Combi heater has a solenoid valve,
which will automatically react to the low level
of water. The water inlet will open to fill up the
tank and steamer session can be continued
without intervention.
In the manual fill, the alarm beeps and “FILL”
will be displayed as long as the user fills the
tank.
However if the user does not refill the tank
and it becomes empty, a high tone interval
beep and “dry” display will alarm the user. The
steamer will automatically be switched off now,
only the heater will be working.
The automatic refill mode will refill itself now,
if it did not refill its tanks earlier. Always check
that the water supply is open before using the
automatic refill Combi heater!
2.3.3 Cabin drying
10 minutes after the steamer session, the
heater will automatically dry the sauna room.
The cabin drying is set to 30 minutes at 70°C;
The total drying state will take 40 minutes. The
remaining cabin drying time will be displayed
on the interface screen.
If the steamer operation is changed to heater
only, there will be no cabin drying at the end
of the session.
The cabin drying session can be stopped
earlier by pushing the power button.
