English
1. Introduction of the Innova Controls
Congratulations on your purchase of Innova Control Unit!
1.1 Precautions
3
Innova Control Unit is developed to enhance your sauna bathing with a
variety of features. It can adjust temperature, humidity, ventilation and
light option in your sauna. The Innova Control Units are available on a
separate or built-in mounting on the Power Controller Board.
The following information provides you with instructions on adjusting
the settings of the control unit. Please, read this instruction manual
carefully before using the control unit. Familiarization of the key
functions will give you a more enjoyable sauna experience.
1.
2.
3.
4.
5.
6.
Only a qualified electrician is allowed to make the electrical connec-
tions and repairs on the unit. Use original parts only.
Disconnect the Power Controller and the Contactor Unit from the
electrical circuit before installation, opening the lid of the power
controller or contactor unit and repair.
Check power supply rating before installation.
Check the correct location of the sensor in the installation section of
the manual. It is very important to place the temperature sensor
correctly as it closeness of the air ventilation cools down the sensor
and may lead to overheating.
The control unit can be operated on a room temperature 0-40°C. Do
not install the control unit inside the sauna room!
Do not pour water in the control unit or clean it with wet cloth. For
cleaning purposes, use a cleaning cloth that has been only slightly
moistened with a mild soapy solvent (dish detergent).
