SATO 8191-00, Инструкция по эксплуатации, Страница: 17 / 28

16
5) Use the [ ▲ ] or [ ▼ ] key to change the alarm value, and then press the ENTER key to confirm.
Pressing and holding the [ ▲ ] or [ ▼ ] key quickly advances the value.
Alarm initial value: Hi setting: 100.0°C
Lo setting: 0.0°C
When the alarm value is confirmed, the upper or lower limit selection display is resumed.
For setting the lower limit alarm value, repeat the steps from 3) above.
When setting another channel, first enter the ESC key to return to the channel setting, and then repeat
the steps from 2) above.
6) Upon completion of setting, press and hold the [ESC] key
for at least two seconds to return to the measurement mode.
If the alarm is successfully set, the character lights
up in the display.
● Alarm operation
If the measured value exceeds or falls short of the alarm set value, the
Hi
or
Lo
character of each channel
flashes, a buzzer sounds and the LED lamp flashes for 30 seconds.
These alarm operations automatically stop after 30 seconds. To stop the alarm mid-way, press any key.
When the alarm is stopped, the
Hi
or
Lo
character stops flashing and remains lit. This indicates that the
measured value exceeds or falls short of the alarm set value.
To clear the
Hi
or Lo character, press and hold the [MAX/MIN] key for at least two seconds. The
Hi
and
Lo
characters are also cleared when entering the setting mode or when the power is turned off.
Offset setting
It is possible to set an offset value in the unit to offset the measured value.
The offset value can be set individually for each channel.
Offset initial value : 0.0°C
Offset setting range : ±12.0°C
The offset setting is applied to the measured value and the logging data.
Note: The offset setting is not applied to the data already logged.
● Offset setting
1) Select the offset setting, and then press the ENTER
key.
The channel selection display appears, and the
OFFSET
character lights up.