SATO 8191-00, Инструкция по эксплуатации, Страница: 16 / 28

15
7) Set the stop date and time in the order of year, month, date, hour and minute.
Use the [ ▲ ] or [ ▼ ] key to select the value, and then press the
[ENTER] key to confirm.
For setting the year, use the lower two digits.
Note: If the preset stop date and time is set earlier than the
preset start date and time, an error occurs and the year
setting is resumed.
8) Upon completion of setting, press and hold the ESC key for at least two seconds. The RES character
lights up to indicate that the preset logging standby mode is set.
Alarm setting
If the measured value goes out of the set value for the alarm, a buzzer sounds and the LED lamp flashes as a
warning. In the alarm function, upper and lower limit values can be set individually for each channel.
* If the alarm function is not needed, set every setting to OFF. All settings are set to OFF at the factory.
● Alarm setting
1) Select the
alarm setting, and then press the [ENTER]
key.
The channel selection display appears and the
character lights up.
2) Use the [ ▲ ] or [ ▼ ] key to select the channel for which the
alarm is to be set, and then press the [ENTER] key.
3) Use the [ ▲ ] or [ ▼ ] key to select the upper limit alarm (Hi) or
the lower limit alarm (Lo), and then press the ENTER key.
The ON or OFF setting for alarm display appears.
4) Use the [ ▲ ] or [ ▼ ] key to select "ON", and then press the
[ENTER] key to display the alarm value setting.