SATELLINE-EASy Pro 35W
User Guide v.1.4
74
10.2
Addressing
Addresses can be used to route a data message to the desired destination or to separate two
parallel networks from each other. In networks with repeaters it is usually necessary to use
addresses to prevent data messages from ending up in loops formed by repeaters. In case of
setting the “Message Routing” function in use, Tx / Rx addresses are ignored by the modem.
SATELLINE-EASy Pro 35W allows the use of individual addresses both for reception and
transmission. Addresses can be switched on separately, or simultaneously, in both data transfer
directions.
The radio modem contains two transmission and two reception addresses, which are knows as the
primary address and secondary address. The primary address is used whenever data from the
serial interface is transmitted. At the receiving end, the radio modem will receive using either of
the two receive addresses.
Secondary transmit address is only used in repeater applications.
Radio modems configured to function as repeaters, will repeat data messages using either the
primary or secondary address, depending upon which address was used during the reception of
the data message.
If only one address pair is needed in a network, both addresses must be set the same
(TX1 = TX2 and RX1 = RX2).
It is also possible to transfer the received address onto the serial interface.
The address is composed of two characters totalling 16 bits, resulting in over 65,000 different
address combinations. The address is attached to the beginning of each data packet sent by the
radio modem. When a radio modem receives a data packet whilst using addressing mode, the
radio modem will check the first two characters of each received data packet to ensure that the
packet in question was intended for the correct radio modem.
ADD H ADD L
DATA
Address may be selected between 0000h…FFFFh (h = hexadecimal, corresponding decimal
numbers are 0-65535).
Example: address 1234h (4660 in decimal format), where 12h is ADD H and 34h is ADD L.
Example: address ABFFh (44031 in decimal format), where ABh is ADD H and FFh is ADD L.
