SATELLINE-EASy Pro 35W
User Guide v.1.4
40
9
SETTINGS
The configuration of SATELLINE-EASy Pro 35W can be easily changed. Simply by connecting
MODE pin (see chapter 6.2) of the data connector to ground (GND) the radio modem will switch
into Programming Mode. Serial PORT 1 is used whenever the radio modem is in the
Programming Mode
. The serial port settings are 9600 bps, N, 8,1 (data transfer speed 9600 bps,
none parity, character length 8 bits and one (1) stop bit).
SATELLINE-EASy Pro 35W contains push buttons and a LCD-display, which can be used to modify
configuration settings without the help of an external terminal device. The radio modem will switch
into
Programming Mode
by pressing the ”SETUP” (
)button.
9.1
Programming Mode
The settings of SATELLINE-EASy Pro 35W are fully configurable in Programming Mode by using
following setup:
-
Satel Configuration Manager software, or alternatively a terminal program (SaTerm,
HyperTerminal etc.)
-
Power cable (C-P-35W)
-
Data Cable (NARS-ST for 8-pin connector)
-
Interface adapter (NARS-1F includes a mechanical switch for easy changing between the
Programing mode and Data Transfer mode)
The radio modem will shift into the Programming Mode by connecting MODE pin (see chapter
6.2) of the data connector to ground (GND). When using the NARS-1F, this can be accomplished
by moving the slide switch towards D-9 connector.
In the
Programming Mode
, the radio modem is forced to use serial PORT1, with settings 9600
bps, N, 8,1 (data transfer speed 9600 bps, none parity, 8 data bits and 1 stop bit).
9.2
Changing parameters using a terminal device
9.2.1
Changing the settings
•
Connect cables (RS-232 cable to PC COM-port, power supply cable to power supply).
•
Switch on the PC and start the terminal program.
•
Set the serial port parameters of the program as follows: 9600 bits/s, 8 data bits, none
parity, 1 stop bit, which is always the default in
Programming Mode
).
