SATEL INTEGRA
Plus
41
2 long beeps
– unknown code/card.
3 long beeps
– unavailable function.
Events signaled by sounds
Only installer selected events are signaled.
5 shor
8.2 Functions available from code lock
t beeps
– zone violation (CHIME).
Very short beeps
–
door open too long
.
Depending on the user type and authority level, as well as the code lock settings, entering
the code and confirming it with the or key will result in:
unlocking the door (activating the relay),
changing over the status of 25. BI
SWITCH
type outputs,
n blocking.
s from the keypad. To trigger an alarm, do the
– press the
turning on the 24. MONO
SWITCH
type outputs,
guard round confirmation,
enabling temporary partitio
The installer can permit triggering alarm
following:
fire alarm
(INT-SZ) /
(INT-SZK) key for approx. 3 seconds,
rm
–
key
medical (auxiliary) ala
press the 0
for approx. 3 seconds,
panic alarm
– press the
(INT-SZ) /
(INT-SZK) key for approx. 3 seconds. The
r th
larm
The installer can permit changing own code by means of the code lock. Proceed in the same
9. Confirming voice messaging
installer defines whethe
e triggered a
will be loud (setting off the loud alarm
signaling) or silent (without loud signaling).
way, as when changing the code by means of the partition keypad (see: p. 38).
The installer can configure the control panel so that confirmation of listening to the voice
r
4
sage has been confirmed, there are no more voice
2 l
he message has not been confirmed).
he
message be required. If there is no confirmation, the control panel can connect many times
for playback of the message. Having listened to the message can be confirmed from the
keypad of DTMF dialing telephone. The installer defines whether any 4-digit sequence is
sufficient to confirm receipt of a voice message, or it must be a specific code. After entering
of the code, the control panel will give the following information by means of sound signals:
1 short beep repeated every 3 seconds
– the message has been confirmed, wait fo
playback of the next voice message,
short and 1 long beeps
– the mes
messages,
ong beeps
– an invalid code has been entered (t
If the control panel is sending messages about several events and confirmation of t
voice messages is required, each message should be confirmed. The first message
must be confirmed before the second message can be played back, an so on.
The installer can configure the control panel so that acknowledgement of receiving the
message by the user will:
clear messaging other users,
