SATEL
GPRS-T1
9
DNS server
– DNS server IP address which is to be used by the converter. The DNS server
address is necessary when GPRS technology is used for sending data, if the address of
the device to which the converter is to connect (monitoring station, computer with
GPRS-S
OFT
program) has been entered as a name. If all addresses are given in the IP
address form (4 decimal numbers separated by dots), programming the DNS server
address is not required.
Module status
USSD codes forwarding message
– content of the control command that must precede
the USSD code in SMS message being sent to the module. The USSD codes make
it possible e.g. to check the account status of SIM card installed in the module. The form of
SMS message must be:
xxxx=yyyy=
, where "xxxx" is the control command, and "yyyy"
- the USSD code served by the operator of GSM network in which the telephone is used
(it depends on the SIM card installed in the module). Having received such an SMS
message, the module will execute the USSD code contained therein. The answer received
from the operator is sent in the form of SMS message to the telephone number from which
the control command was sent.
Note: Using the advanced functions available due to the USSD service (when menu is
presented in reply to the code entered) is not recommended.
Autorestart every
– if the restart of module settings is to be periodically repeated, you must
define every how many hours it is to happen. The first restart of module settings will occur
after the programmed time has elapsed since the settings were written to the module. If 0
is entered, the function will be disabled.
Monitoring station 1 / Monitoring station 2
Notes:
•
Using GPRS technology, event codes can be sent to the STAM-2 monitoring station or to
the SMET-256 converter.
•
Communication with the subscriber sending event codes with the use of GPRS
technology should be tested by the monitoring station as rarely as possible (if a value
lower than 1 minute is entered in the "Test period" field of the monitoring station, the time
will be rounded up by the converter to 1 minute). It is recommended that the maximum
value be set, i.e. 255 seconds.
•
If the converter is to send event codes using GPRS technology, an adequate number of
attempts to connect to the monitoring station is to be programmed in the control panel.
Thus the converter will have time for receiving event receipt acknowledgement from the
monitoring station.
Disabled
– if this option is selected, event codes will not be sent to the monitoring station.
SMS
– if this option is selected, event codes will be sent to the monitoring station in the form
of SMS messages.
GPRS
– if this option is selected, event codes will be sent to the monitoring station with
the use of GPRS technology.
GPRS, SMS if GPRS failure
– if this option is selected, event codes will be sent to the
monitoring station with the use of GPRS technology, but after a failed attempt of sending
events (lack of receipt acknowledgement from the monitoring station), the event code will
be sent in the form of SMS message.
Tel. number (SMS)
– GSM telephone number used by the monitoring station for receiving
SMS messages. Must be preceded by the country code.
Address (GPRS)
– address of the monitoring station. It can be entered in the IP address
form (4 decimal numbers separated by dots) or as a name.
