Sargent and Greenleaf Touchless ADO, Руководство по установке

Страница: 22 / 48

SARGENT & GREENLEAF ■ WWW.SARGENTANDGREENLEAF.COM
[t] 800.826.7652 ■ 859.885.9411 ■ E-mail: (Information Required) ■ One Security Dr. Nicholasville, Kentucky 40356
S&G TOUCHLESS ADO.docx REV - 08/2021 22
•
Before installing any portion of the door arm assembly, it is easiest to lay the arm out on a flat
surface and insert the secondary and primary arm into the sleeve as it will be when installed on the
door:
o
Slide the short arms within the sleeve to obtain the prescribed "X" dimension. If the reveal falls
between two of the values on the chart, use ( 13”) for hinge hung doors, or ( 16”)
for Center Pivot doors
o
Tighten the screws on the short arm that is connected to the door shoe.
o
Double-check the "X" dimension of the arm - this is the distance between the center of the hole
at the door shoe and the center of the hole at the pivot point of the primary arm (as shown).
o
Mark a pencil line at the edge of the sleeve where it overlaps the short arm that is connected to
the primary arm. This will make it easier when positioning the primary arm for final installation.
o
After marking the line, remove the primary arm assembly only from the sleeve.