54
3. To reinstall the spa pillow, carefully bend the pillow slightly to allow the pins to slip into the pin
retainer on the spa shell.
4. Keeping the pillow slightly bent, slide the other pins (opposite end) onto the pin retainer on the
spa shell.
5. After all the pillow pins are in place, press the pillow down into the recess in the spa shell.
Important:
Just pulling the pillow straight up, and out of the shell recess, will eventually
damage the pillow. This abuse is not covered under warranty.
Care of the Exterior
Spa Shell
Your Saratoga Spa is manufactured with a tough acrylic surface. Some staining or water
marking may occur at or above the water surface. Removal of these surface conditions can
usually be accomplished with a soft cloth by merely wiping them away. Stubborn stains can
be removed first by draining the spa and then using a nonabrasive product. Always
thoroughly rinse off any spa shell cleaning agent with fresh water.
Important:
Keep all cleaners out of the reach of children and use care when applying.
Spa Cabinet
The skirt around your Saratoga Spa is manufactured with the finest quality material and is
available in a low maintenance exterior.
WeatherAll™ Skirt
The WeatherAll™ skirt combines the durability of plastic with the look of professionally
finished wood.To remove any stains or dirt simply spray the skirt with water and wipe
down with a soft cloth.WeatherAll™ is not designed to be stained or resealed.
Note:
WeatherAll™ could experience natural fading due to sunlight and weather exposure.
Care of the Spa Cover
Vinyl Cover
Your vinyl thermal spa cover has been designed for your particular spa. Monthly cleaning and
conditioning is recommended to maintain its beauty.
To clean and condition the vinyl cover:
1. Remove the cover from the spa and gently lean it against a wall or fence.
2. With a garden hose, spray the cover to loosen and rinse away dirt or debris.
3. Using a large, non-abrasive sponge and using a very mild soap solution (one teaspoon dishwashing
liquid with two gallons of water) scrub the vinyl top in a circular motion. Make sure to rinse all
soap off the cover before it dries.
4. Scrub the cover’s perimeter and side flaps. Rinse clean with water.
5. Rinse off the underside of the cover with water only (use no soap), and wipe it clean with a dry
rag.
6. To condition the cover after cleaning, apply a thin film of saddle soap (follow directions on the
container) or vinyl conditioning cream.