Sapphire Audio rage, Руководство по эксплуатации и обслуживанию

Страница: 8 / 73

SECTION 1
PART# 49-057 REV K
SAPPHIRE SCIENTIFIC RAGE
®
4
8. NEVER service this unit while it is running.
High speed mechanical parts as well as high
temperature components may result in injury or
severed limbs.
9. Engine components will be extremely hot
from operation. To prevent severe burns, DO
NOT touch these areas while the unit is running
or shortly after the unit is shut off.
10. DO NOT touch any part of the exhaust
system while the system is running or for 20
minutes after the unit is shut off. Severe burns
could result.
11. Water under high pressure at high
temperature can cause burns, severe personal
injury, or fatality
. Shut down unit, allow it to
cool down and relieve the system of all pressure
before removing caps, valves, plugs, fittings,
filters or hardware.
12. NEVER leave the vehicle engine running
while the unit is in operation.
13. Battery acid contains sulfuric acid . To
prevent acid burns, avoid contact with skin, eyes
and clothing. Batteries also produce explosive
hydrogen gases while charging. To prevent fire
or explosion, charge batteries only in a well-
ventilated area. Keep sparks, open flames, as
well as other sources of ignition away from
battery at all times. Remove all jewelry prior to
servicing batteries. Keep batteries out of the
reach of children.
Before disconnecting the negative (−) ground
cable, ensure that all switches are in the off
position. If on, a spark could occur at the ground
connection terminal which could cause an
explosion if hydrogen gas or gasoline vapors are
present. ALWAYS disconnect the negative (−)
terminal first.
14. DO NOT smoke around the machine. Gas
fumes could accumulate and ignite. Battery
gases are extremely flammable. This will
prevent possible explosions.
15. DO NOT damage the vehicle in any way
during the installation. When routing fuel lines
DO NOT configure the hose in any locations
where the hose or vehicle could be damaged.
Avoid contact with moving parts, hot surfaces,
brake lines, fuel lines, catalytic converters,
exhaust pipes, mufflers or sharp objects.
16. NEVER cut or splice any of the vehicle fuel
lines during fuel line installation. This will result
in fuel leaks and potentially dangerous
conditions. Use only the provided fuel hose for
fuel lines. When going through the vehicle floor
with fuel lines, always utilize bulkhead adaptors.
This will prevent fuel leaks and ensure that hoses
are not punctured by vehicle vibration abrasion.
17. DO NOT exceed your vehicles weight limit.
The console with waste tank and accessories
weighs approximately 858 pounds. Make certain
that the vehicle has the correct axle rating. This
will prevent unsafe or hazardous driving
conditions.
18. High back seats are required for all vehicles
that units are to be installed for head and neck
protection. Metal partitions between the seats
and equipment are strongly recommended.
19. DO NOT operate this unit without the water
supply on and attached. The water pump and
other vital components could be seriously
damaged if the unit is operated dry.
20. Always keep your vehicle clean and orderly.
Wands, tools and accessories must be securely
stowed while driving the vehicle.
21. All high-pressure hoses must be rated at
3000 PSI and have a heat rating of 250 degrees
F. Thermoplastic hoses do not meet this criteria
and should never be used. Severe burns and
other injuries could result if hoses do not meet
these requirements.