Sapphire Audio rage, Руководство по эксплуатации и обслуживанию

Страница: 28 / 73

SECTION 3
PART# 49-057 REV K
SAPPHIRE SCIENTIFIC RAGE
®
22
HEAT BYPASS OPERATION
The heat bypass has 2 purposes.
1. To cool down the unit at the end of the job
when using for carpet cleaning. When finished
with the job, open the heat bypass while coiling
up the hoses to allow water to circulate through
the unit and prevent excess heat buildup.
2.
In flood extraction mode, open the valve 1/4
turn to keep water circulating through the
pump to prevent pump overheating and
premature failure.
SHUT DOWN AND DAILY
MAINTENANCE
1. Flush out the chemical system with fresh water
to remove any chemical residue.
2. Remove as much moisture from the vacuum
hoses as possible. This will prevent spillage of
wastewater in your vehicle when returning hoses.
3. Disconnect the vacuum hose from the front of
the unit.
4. Adjust the throttle cable to the idle position.
5. Allow the unit to run at 50% throttle
for a few
minutes . This will also help to remove any
excess moisture from the vacuum pump and cool
the unit down.
NOTE: If shutting down for the day: Plug the
vacuum inlet on the front of the unit and set the
throttle control cable to high. Spray WD-40 (or
equivalent) into the
blower lubrication cup,
located on the left hand side of the control panel
for
5 seconds . Let machine run 2 minutes to
disperse lube to blower. Unplug the vacuum inlet
and remove load. Next, return the throttle control
cable to idle
position , and let idle for 3 to 5
minutes.
6. Turn the ignition switch to the OFF position.
7. Turn the water supply faucet off. Loosen the
water supply hose at the water supply to bleed off
any pressure. Unhook the water supply hose and
return it to the vehicle.
8. Activate the valves on all cleaning tools. This
will relieve any remaining pressure. Disconnect
the cleaning tools and solution hoses and return
them to the vehicle.
9. Drain the waste tank, disposing of wastewater
in a suitable and proper location.
!
NEVER
dispose of wastewater in a storm drain,
water way or on ground areas. Always dispose of
waste in accordance with Local, State, and
Federal laws.
10. Remove the strainer basket from the waste
tank. Clean out any debris and re-install.
Microban QGC cleaner is the best product for
cleaning and sanitizing the waste tanks as well as
other parts of the system
NOTE: Damage may occur to the vacuum pump.
Replacement and maintenance of the filter will
prevent rust and corrosion from entering the
vacuum pump.
11. Inspect the vacuum inlet filter inside the
waste tank
daily . Remove and clean the filter if
there is any lint or debris present.
NOTE: To remove the vacuum inlet filter, grip
the plastic hexagon section of the filter. Gripping
the filter by the screen will collapse or destroy
the filter. After cleaning, grease the threads on
the filter and replace the filter. Tighten the filter
until hand tight and then loosen ¼ turn. This will
make the filter easier to remove when cleaning or
replacement is required.
NEVER operate this unit with the filter removed,
damaged or improperly installed.