SECTION 3
PART#
49-057 REV K
SAPPHIRE SCIENTIFIC RAGE
®
21
!
NEVER
dispose of waste water in a storm drain,
water way or on ground areas. Always dispose of
waste in accordance with Local, State and
Federal laws.
OPERATION
When operating the unit for cleaning or
restoration, the unit should be in the
maximum throttle position. This ensures full
vacuum and performance from the unit
.
NOTE: During flood extraction the throttle
control must be set to maximum.
CLEANING
While cleaning, observe the following guidelines:
1. Before cleaning, ensure that the wand nozzles
are functioning properly.
A.
Hold the wand approximately one foot
above the surface to be cleaned and open
the wand valve. A full even spray should
emit from the cleaning nozzles.
B.
If the nozzles are not showing a full
even
spray pattern, adjust, clean, or replace the
nozzles, if required.
2. Usually, chemical solution is applied during
the push stroke of the wand during cleaning, and
extraction is done on the pull stroke. For heavily
soiled carpets, the wand may be used in a
scrubbing action, with chemical solution applied
in both push and pull strokes, provided that the
final stroke is a pull stroke with no chemical
injection.
UPHOLSTERY CLEANING
1. Upholstery tools have a lower flow rate and
smaller orifices. It may be necessary to slow the
engine down and partially open the bypass valve
to maintain proper cleaning.
FLOOD
RESTORATION/EXTRACTION
This machine can be used for limited water
extraction only if connected to an adequate water
source and the bypass valve is opened 1/4 turn.
!
NEVER RUN THE PRESSURE PUMP DRY
.
Doing so will quickly build up heat in the pump
which may cause severe damage to internal
components
An automatic waste pump-out is highly
recommended when performing flood extraction
to avoid shutdown from filling the waste tank.
1. Set the throttle control cable on the front
control panel to maximum.
2. If an automatic waste pump-out is equipped,
set the PUMP OUT switch to the ON position.
3. Proceed into the extraction process.
To prevent excess heat build-up in the unit, do
not restrict air flow to the wand head when not
extracting water. If the wand must be placed
down, position the head sideways or upside
down.
NOTE: A float shut-off switch is located inside
of the waste tank. It will automatically shut
down the unit if the tank reaches its full
capacity. If this occurs, empty the waste tank
before continuing.
Содержание rage
