SSP Settings (RS-485)
Connection Examples for Equipment with SSP
(Dome Camera)
Turn off the power supply for all equipment, and
then use twisted pair cables to connect the
devices that are equipped with an RS-485
control connector to the video server.
1
Make the following connections.
Camera A: Connect a normal CCD camera
to VIDEO IN 1 and 2.
Camera B: Connect a dome camera with
SSP function to VIDEO IN 3 and 4.
2
Click the [SINGLE VIEW] menu select
button.
The control panel for equipment with SSP
function will be displayed.
3
Set “CATEGORY” to “CAM”.
While looking at the images from camera B
that are being transmitted via the network,
click the CAM buttons to pan and tilt the
dome camera.
Note:
Camera A is for monitoring images only; it
cannot be operated using the CAM buttons.
Note:
•
The twisted pair cables should always have signal A
connected to signal A, and signal B connected to
signal B, and the ground should always be
connected too.
•
If more than one device is connected, enable the
termination settings for the devices at both ends of
the series. Set communication/terminal select switch
1 at the rear of the video server to the “ON” position,
and set the termination switch for the last device in
the series to “ON”. All other devices should have the
termination settings set to “OFF”.
GND
12VDC
IN
OUT
VIDEO 1
IN
OUT
VIDEO 2
IN
A
1
2
3
4
RS-232C
COM
COM
ALARM
OUT
ALARM
IN
RS485
TERMI
ON
MODEM
ETHERNET
ALL RESET
PC
B A B
OUT
VIDEO 3
IN
OUT
VIDEO 4
1 2
Computer
Monitor TV
Camera A
Camera B
3
L8NAA/XE
(VSP-SV2000P) GB 2003,
5,
12
– 54 –
English
