Sanyo CLT-D14, Инструкция по эксплуатации

Страница: 29 / 40

29
DIGITAL ANSWERING MACHINE
LED Status
Lit steadily in green Answering Machine ON
Off Answering Machine OFF
Flashing slowly in green New Message(s) recorded
Flashing rapidly in green The recording memory is full
Flashing in red Phone Ringing
Message LED Indications
REMOTE ACCESS
You can check messages from any touch-tone phone to control the
answering machine from a remote location.
Using a touch-tone telephone, you can call the CLT-D14 from outside
and access the unit to listen to messages or change answering system
settings. In order to operate the answering system remotely, you
must first enter remote access code, this code prevents unauthorized
parties from listening to your messages remotely. The remote code
(4 digits) of your CLT-D14 is shown on a label at the bottom of base
unit.
Depending on how the answering machine has been switched ON
or OFF, you may call and enter the Remote Access from any touch-
tone telephone as follows:
1. If the answering machine has been switched OFF, the answering
machine will respond and answer the call after 15 rings. There
will be no message played to the telephone line during auto-
answering, you will have 8 seconds to enter the remote access
code (printed at the bottom of the CLT-D14 base unit). If the remote
access code is correct, you will hear a beep tone to indicate the
answering machine has entered the remote access mode.