Santint
PA Series Paint Mixing Machine V1.1
8
9)Pulling Strip
Hang the pulling strip on the hanging
shaft of the side plate
（
5.2.24
）
. Use the
turn buckle to hook the hole on the pulling
strip. Tension the pulling strip. Install the
other pulling strip in the same way.
The turn buckle at the back of the mixing
machine shall be rotated to tension the
pulling strip. The left/right side plate shall
be vertical with the ground.
10)Switch Box and Pilot Run.
Insert the three fixing shafts of the switch into the three holes of the left side plate. Press them
down to fasten the switch box onto the left side plate (5.2.25
，
5.2.26).
Now the equipment has been assembled.
Connect the power supply (see the Usage section). Check the equipment during the operation. If
there is any issue, solve it by referencing the Troubleshooting section.
11) Attached Spare Parts
①
The bolt type binding band is for fixing
the power line and the switch box
controlling line. Insert it into the saved
installation hole on the left side plate then
fix the motor wire.
（
5.2.27/5.2.28
）；
②
Sealing plate of the shelves shall be used
to seal the saved shelf holes.
（
5.2.29
）
.
5.2.25
5.2.26
Saved
Hole
5.2.24
5.2.27
5.2.28
5.2.29
