SanRex CALPOTE UG Series, Инструкция по эксплуатации

Страница: 35 / 97

35
Display
symbol
Name Setting range
Incremen
t
Unit
Default
value
Changeabl
e during
operation
(proportional) signal
E Soft-start time 0.0 to 300.0 0.1 s 0.5 ✓
C
Current limit
amount
10 to 110 1 % 110 ✓
U
Heater
disconnection
amount
5 to 50 1 % 50 ✓
d Delay time 0.0 to 3.0 0.1 s 0.0 ✓
t Period 1.0 to 3.0 0.1 s 1.0 ✓
n
Function
characteristics
0 to 7 1 No. 0 ✗
↑
(“during operation”... the operation status LED is ON or flashes,
i.e. output is generated.)
Parameter overview

P: Temperature control signal
One of the output setting signals, this signal functions in the same way as the “+,” “S,”
and “–” terminals on the control terminal block. If [F2 P: Priority setting] is set to [0: Control
terminal block], the value set with the temperature controller can be checked when this item
is selected If [F2 P: Priority setting] is set to [1: Panel] or [2: Communication], the value can
be set via the panel or communication as a substitute for the temperature controller.

H: Manual (upper limit) signal
One of the output setting signals, this signal functions in the same way as the “VH2”
terminal on the control terminal block. If [F2 H: Priority setting] is set to [0: Control terminal
block], the value set with the variable resistor can be checked when this item is selected. If
[F2 H: Priority setting] is set to [1: Panel] or [2: Communication], the value can be set via the
panel or communication as a substitute for the variable resistor input.

L: Lower point (lower limit) signal
One of the output setting signals, this signal functions in the same way as the “VL2”
terminal on the control terminal block. If [F2 L: Priority setting] is set to [0: Control terminal
block], the value set with the variable resistor can be checked when this item is selected. If
[F2 L: Priority setting] is set to [1: Panel] or [2: Communication], the value can be set via the
panel or communication as a substitute for the variable resistor input.