16
ENGLISH
www.sanitairecommercial.com
Problem solving
Problem
Cause
Solution
Motor will not start
Power switch
Turn power switch to ON position and wait a moment.
After turning switch ON, expect a short delay before
motor starts.
Power plug
• Push plug securely into outlet.
• Try another outlet.
• Check circuit breaker.
Thermal cut-off
Refer to p. 3
Vacuum cleaner
does not clean
Dust bag and filters
Replace dust bag, clean and/or change filters.
Air path blocked
Remove debris from air path. Refer to p. 10-11.
No suction at end of hose
Check hose for blockage. Refer to p. 10-11.
Carpet height setting
Adjust knob to lower position. Refer to p. 10-11.
Red warning light is on
Brushroll stall, full bag
or blockage
Replace dust bag or clear blockage. Push the power
switch to OFF to reset. Refer to p. 10-15.
Vacuum cleaner is
hard to push
Carpet height setting
Adjust knob to higher position. Refer to p. 8-9.
Deep pile carpet,
including super plush.
Adjust suction control as needed. Refer to p. 8-9.
Front cover will not close
No dust bag
Install dust bag properly. Refer to p. 12-13.
Make sure vacuum is turned off and electrical power cord is unplugged.
