11
Pipeless Whirlpool Bath
Installation Instructions
WaRnIng
When using electrical products, basic precautions should always be followed, including the following:
1
IMPORTANT: Read complete instructions before beginning installation.
2
DANGER: RISK OF ELECTRIC SHOCK.
Connect only to a dedicated 15 amp. circuit protected by a ground fault
circuit interrupter. Grounding is required. This unit should be installed by a qualified service representative
and grounded.
3 Each whirlpool bath arrives ready for installation and may include an optional drain/overflow kit.
4 Remove the bath from the carton and retain the shipping carton until satisfactory inspection of the product has
been made. ONLY lift the bath by the shell or base.
5 To help prevent damage from shoes, tools, etc., to the bath unit’s finish during installation, do not remove the
protective sheet of plastic from inside the bath.
6 Immediately upon receipt, inspect the tub shell and operating system for any obvious damage BEFORE installing.
Should inspection reveal any damage or defect in the finish, do not install the bath. SANIJET’s responsibility for
shipping damage ceases upon delivery of the product in good order to the carrier. Refer any claim for damage
to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty information
on pages 16 and 17.
7 All bath units are factory tested for proper operation and watertight connections prior to shipping.
note: Prior
to installation, the bath must be filled with water and operated to check for leaks that may have resulted
from shipping damage or mishandling.
8 Each SANIJET Signature and Designer Collection model has an internal access panel and does not require an
external access panel for service:
9
CAUTION: RISK OF ELECTRIC SHOCK:
De-energize from electrical supply before servicing.
