Sanden Vendo Vue SXY 30, Руководство пользователя

Страница: 41 / 128

P-9
Part #1167879 08/2008
ALWAYS ENSURE THE CLAMP HAND HAS RETRACTED
BEFORE CLOSING THE DOOR
Note – When you are in any Test Motor operation where the ‘HAND’ is Extended be sure to
EXIT MODE on Button 1 before closing the Door
Test Mode Sensors Status:
Note: If the sensors are being replaced, press ‘4’ to refresh the sensor status.
1. Press Button 2 to scroll until “Sensors Status” is displayed.
2. Enter on Button 4 - Sensors Status display as follow:
STANDARD FONT DISPLAY
●
– Inactive, or
○ –
Active
EUROPEAN FONT DISPLAY
∑
– Inactive, or
σ –
Active
X
●
OR
○
- X Home Sensor located on Z Housing
X
∑
OR
σ
X
●
OR
○
- Y Home Sensor located on the X Rail
X
∑
OR
σ
X
●
OR
○
- Z Home Sensor located on the PDC
X
∑
OR
σ
X
●
OR
○
- Hand Clamp Sensor located on the Hand
X
∑
OR
σ
X
●
OR
○
-
Forward Looking Optics
located on the top right corner of the Hand.
X
∑
OR
σ
Note: If any ‘Reflectors’ are removed/ fall off of the Hinged or Lock Side of the vendor and it
is a 5 shelf unit – it will fail the Discovery. In ‘Discovery’ they must be on all outside shelves.
The middle shelves do not matter.
Test Mode Display:
1. Press Button 2 to scroll until “Display” is displayed.
2. Enter on Button 4
3. The 20 ‘boxes of pixels’ on each line should illuminate
4. Exit on Button 1
Test Mode Switches:
1. Press Button 2 to scroll until “Switches” is displayed.
2. Enter on Button 4
3. Activation of individual selection buttons (1 – 12) for SXY40, (1 – 8) for SXY30
should display