2 S&C Instruction Sheet 1072-530
Qualified Persons
WARNING
The equipment covered by this publication must be installed, operated, and maintained by
qualified persons who are knowledgeable in the installation, operation, and maintenance
of radios in electric power distribution equipment, along with the associated hazards. A
qualified person is a radio technician who is qualified to install transmission-power-limited
radio equipment per FCC Part 15 and who is trained and competent in:
• The skills and techniques necessary to distinguish exposed live parts from nonlive
parts of electrical equipment
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
• The proper use of the special precautionary techniques, personal protective equip-
ment, insulating and shielding materials, and insulated tools for working on or near
exposed energized parts of electrical equipment
These instructions are intended only for such qualified persons. They are not intended
to be a substitute for adequate training and experience in safety procedures for this
type of equipment.
Read this
Instruction Sheet
NOTICE
Thoroughly and carefully read this instruction sheet before programming, operating, or
maintaining your S&C SpeedNet Radios. Familiarize yourself with the Safety Informa-
tion and Safety Precautions on pages 5 and 6. The latest version is available online in
PDF format at
sandc.com/Support/Product-Literature.asp
These instructions apply to SpeedNet Radio Firmware Version v2.5.3. The version
number can be found on the
Admin>System
window of the SpeedNet Client Tool version
2.5.3, as shown in Figure 1.
Retain this
Instruction Sheet
This instruction sheet should be available for reference wherever SpeedNet Radio is to
be used. Retain this instruction sheet in a location where you can easily retrieve and
refer to it.
Introduction
Figure 1. Admin>System window in the SpeedNet Client Tool
