S&C 5800 Series, Руководство по установке, Страница: 26 / 38

26 S&C Instruction Sheet 1042-511
Installation
STEP 7. For pad-mounted controls, connect and test the door switch by following this
procedure:
(a) Connect the switch control 3-pin connector to the harness from the door switch of
the low-voltage cabinet. Skip this step for factory-installed controls.
(b) Press the door switch lever, and make sure this turns off the faceplate LEDs and LCD
screen. When the lever is released, the LEDs and LCD screen should be lit. If they are
not lit, see Instruction Sheet 1042-550, “S&C 5800 Series Automatic Switch Control
with IntelliTeam
®
Automatic Restoration System: Troubleshooting .”
The switch control uses the door switch status to know when to provide power
to the faceplate LEDs and LCD screen. If the low-voltage cabinet does not have a
door switch, contact the manufacturer.
If necessary, make sure the communications equipment has power. For overhead switch
controls, the communication equipment is on the back of the faceplate. For 5800 Series Switch
Controls installed in pad-mounted gear, the communication equipment is not mounted inside
the 5800 Series Control chassis.
Remove any temporarily installed bypass that was applied at Step 3 on page 10.
This makes the switch control available for local, non-automatic operation from the
faceplate.
WARNING
Be sure to leave the switch control in Local (not Remote ) mode and Automatic Oper-
ation in
Disable
(not
Enable
) mode until configuration of the software in the switch
control has been completed .
This completes hardware installation and testing. The following pages of this instruction
sheet show the installation and wiring diagrams.
Go to Instruction Sheet 1042-530, “S&C 5800 Series Automatic Switch Control with
IntelliTeam
®
Automatic Restoration System: Setup, ” to configure the control.
Checking
Communication
Equipment
Local/Non-Automatic
Service