S&C 5800 Series, Руководство по установке

Страница: 24 / 38

24 S&C Instruction Sheet 1042-511
Installation
STEP 3. Test the faceplate functions by using the following procedure.
At this point, installers can test most of the faceplate LEDs and switches. See
Figure 16.
Figure 16. S&C 5801 control faceplate.
To test the LEDs and switches:
(a) Check whether the PROCESSOR STATUS LED on the faceplate is blinking. If it is not
blinking, see Instruction Sheet 1042-550, “S&C 5800 Series Automatic Switch
Control with IntelliTeam
®
Automatic Restoration System: Troubleshooting .”
(b) Hold the BATTERY TEST/LAMP TEST switch in the Lamp Test position and check
that all the faceplate LEDs blink.
(c) Toggle the BATTERY TEST/LAMP TEST switch to the
Battery Test
position. The
BATTERY LOW LED will begin blinking when the switch is released. It will blink for
approximately 1 minute. When the LED stops blinking, the LED goes off if the
battery system is good. If it stays lit, see Instruction Sheet 1042-550, “S&C 5800
Series Automatic Switch Control with IntelliTeam
®
Automatic Restoration System:
Troubleshooting .”
(d) Check that the LCD screen is backlit and that data are displayed. Then, toggle
both DATA SCROLL switches to make sure the display will scroll in all four
directions.
(e) Check that the REMOTE/LOCAL switch on the faceplate is set to Local mode. The
LOCAL LED should be lit.
(f) Toggle the Automatic Operation ENABLE/DISABLE switch and check that the
correct ENABLED or DISABLED LED is lit when the switch is in each position.
If the Features Enabled setpoint on the Setup>Automatic Opera-
tion screen is set to the
None
selection (for either Switch 1 or Switch 2,
if applicable), the DISABLED LED remains lit and the ENABLED LED
remains off when toggling the switch. See Instruction Sheet 1042-530,
“S&C 5800 Series Automatic Switch Control with IntelliTeam
®
Automatic
Restoration System: Setup .”
(g) After checking faceplate operation, leave the REMOTE/LOCAL switch in the Local
position, and leave the Automatic Operation
ENABLE/DISABLE
switch in the
Disable position.