S&C 5800 Series, Руководство по установке

Страница: 15 / 38

S&C Instruction Sheet 1042-511 15
Installation
STEP 8. For controls connected to a Scada-Mate Switching System, check whether a
16-pin/24-pin cable adapter is necessary.
S&C provides a cable for connecting the switch to the FIC on the switch control.
Early Scada-Mate switch cables used a 16-pin connector. If retrofitting a switch
control to an older Scada-Mate switch, the 16-pin/24-pin cable adapter, available
from S&C, is required. The adapter is only necessary for early Scada-Mate switches.
STEP 9.
Install the switch control at the site, and configure the equipment.
The following steps can be completed in the shop or later at the installation site. The steps
are summarized here and described in detail in the IntelliTeam
®
II Automatic Restoration
System instruction sheets.
STEP 1. Install the IntelliLink Setup Software on your computer.
For details, see the “ To Install the IntelliLink Software” section in Instruction
Sheet 1042-530, “S&C 5800 Series Automatic Switch Control with IntelliTeam
®
Automatic Restoration System: Setup .”
STEP 2.
If the switch control uses a modem for communication, configure the modem.
For modem configuration instructions, see the manufacturer’s documentation or
contact S&C.
STEP 3.
If the switch control uses a radio, configure the radio.
For radio configuration instructions, see the manufacturer’s documentation or
contact S&C.
STEP 4.
If a repeater radio is needed to link this switch control to the other team members,
configure the repeater radio.
For radio configuration instructions, see the manufacturer’s documentation or
contact S&C.
STEP 5. Set up the control software in this switch control.
Most of the software setup and configuration can be completed in the shop. For an
explanation of how to set up the software, see the “ To Install the IntelliLink
Software” section in Instruction Sheet 1042-530, “S&C 5800 Series Automatic Switch
Control with IntelliTeam
®
Automatic Restoration System:
Setup .”
Optional In-Shop
Setup