MU-201 GPS/GPRS Nano Tracker User Manual
Copyright © 2011 San Jose Technology, Inc. All Rights Reserved.
25
Auto Report by Distance
The GPS (GPRMC) data can report to server or cellular phone automatically during a period of time or during a distance
of travel.
Use this command to set up the distance Auto Report. The device will report only when both time interval and distance
traveled are matched. If you send the SMS command as the following example, the device will check the distance traveled
every 5 minutes (300 seconds) with previous GPS data, the device will send Auto Report if the distance exceeds 100m
from last known position, or it will not send report if the distance does not exceed 100m, it will check the distance again
at the next 5 minute time interval. The total number of reports times is 99.
Setup Format: #
「
User Name
」
,
「
Password
」
,
「
Function Mode
」
,
「
Intervals (sec.)
」
,
「
Total number of reports
」
,
「
Distance
Interval(m)
」
,,[Time Unit(s/m/h)]*
Command: #username,0000,6,300,99,100*
NOTE: When the “Distance” interval or “Stationary Detection” is set, the tracker status (event) will be “AGF” instead of
“AUTO”.
SMS/ COTA Command
Description
#
Start sign.
username
Default user name of the device.
If you have changed the username, please use the updated one.
0000
Default password.
If you have changed the password, please use the updated one.
6
Mode 6 defines Auto Report setup mode.
300
Time Interval (period) of Auto Report.
99
Times (frequency) of Auto Reports that will be sent automatically.
100
Distance Interval: when the auto report function is activated, the tracker will take the
current position as the start. If this value is defined, when the tracker exceeds the distance
traveled during a time of period, the event report will be sent to the assigned route. The
unit of this function is meter. The minimum distance setting is 100m.
s
Time Unit as “s” for seconds (default), “m” for minutes, and “h” for hours.
*
End sign.
Table: Auto Report by Distance Setup Format Description
Situation
Message Reply
Setup Succeeds
<OK>AGF setup, V3.793;56%
Emergency Mode
<FAIL>PANIC ON; Command not Allow!,V4.091;98%
Table: Auto Report by Distance Setup Response Description