19
5.6 Set up Auto Report
Use this command to set up the frequency of Auto Report. If you send the SMS according to the example shown below to
GC-101, you will have an Auto Report Message every 300 seconds for 99 messages. Once the loop is done, you can send
a SMS message to update/renew, or switching off it in order to renew it.
Note1: You may limit the amount of the Auto reply messages by inputting the digits from 1 to 9998 in the
「
total number
of report
」
field. When you input 9999, the Auto Report Message will not stop unless you define a new Auto Report Setting.
Setup format
：
#
「
username
」
,
「
Password
」
,
「
Function Code
」
,
「
intervals (sec)
」
,
「
total number of report
」
*
Example1
：
#username,0000,6,300,99*
The table 5.6.1 describes the meaning of each segment in the message above.
Table 5.6.1
The table 5.6.2 shows each confirmation message reply after setup
Table 5.6.2
Text Keyed In SMS
Description
#
Start sign.
username
Default ID of GC-101.
If you have changed the Username, please use the updated one.
0000
Default password.
If you have changed the password, please use the updated one.
6
Mode 6 defines to change the intervals and times of sending-back data
300
A constant interval of sending data
99
The amount of 99 messages sent automatically
*
End sign.
Situation
Message Reply
Setup Succeeds
[username] + Setup OK.GC-101 Auto Report setting is updated.
Setup Fail
[username] + Auto Report setting Setup Fail!
Incorrect password
[username] + Password setup Fail!
Incorrect username or command format [username] + command error
GC-101 is in Emergency Mode
[username] + in emergency, Auto Report setting is not allowed.
